Abstract
This specification covers materials proposed for use as admixtures to be added to a Portland-cement shotcrete mixture for the purpose of altering the properties of the mixture. The material shall be classified as Type I (dry mix shotcrete, with Grades 1-9) and Type II (wet-mix shotcrete, with Grades 1-9). Each of the grades shall be further classified by identifying it accordingly as Class A (liquid) or Class B (non-liquid). Shotcrete admixtures shall conform to the requirements for the applicable type and grade. Samples shall be either grab or composite samples, as specified or required by this specification. The number of tests and retests to be performed on the specified materials shall be the number stipulated in the referenced standard.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification covers materials proposed for use as admixtures to be added to a portland-cement shotcrete mixture for the purpose of altering the properties of the mixture.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
Reproduced, with permission, from the ASTM International website, copyright ASTM International, 100 Barr Harbor Drive, West Conshohocken, PA 19428. To purchase the complete standard, go to http://www.astm.org/.
